Compleo | Solo Advanced/Duo - Configuration for ChargePilot

Connection to the charger

Local connection

• The Compleo can be configured via a web interface (ducto): Ducto_Guide.pdf

  • Set the laptop local network IP to 192.168.1.XX

  • Enter the IP-address 192.168.1.100 in a web browser. It dierects to the Compleo Solo ducto page

Remote connection

•  Can be used to access the web interface.

  • Go to Login

  • Tick the box “Login as electrician”

Network settings

• Go to Settings → Network

  • Set operation mode to Ethernet DHCP + service modem

• Apply and confirm the changes

• Restart the charger (or later)

OCPP settings

OCPP connection

• Go to Settings → Backend → Connection

  • Backend URL: ws://172.22.0.1:9000

  • Apply and confirm the changes

  • Restart the charger (or later)

OCPP operating mode

• Go to Settings → Backend

  • Set OCPP operating mode to Online

• Apply and confirm the changes

• Restart the charger (or later)

OCPP Device ID

• Go to Settings → Backend → Connection

  • Set CharegerBoxIdentity, which should be agreed with the customer and comply with the Device ID of the charge point on the Admin UI later

• Apply and confirm the changes

• Restart the charger (or later)

Other charger settings

Maximum current and phase mapping

• Go to Settings → Charging station

  • Set External maximum current to the fuse connetion at the charger, according to the installation protocol

  • Set Adjustable maximum current for the eintire charger. This value should be lower than the internal and external maximum current

  • Apply and confirm the changes

  • Restart the charger (or later)

Connector name

• Go to Settings → Connectors → Connector Type2

  • Set EVSE ID (this will be shown as the plug name in the log)

• Apply and confirm the changes

• Restart the charger (or later)